Back to album

NACA Engineer Examines Wind Tunnel Compressor Blades

An engineer examines the main compressor for the 10- by 10-Foot Supersonic Wind Tunnel at the National Advisory Committee for Aeronautics (NACA) Lewis Flight Propulsion Laboratory.

 

The engineers were preparing the new wind tunnel for its initial runs in early 1956. The 10- by 10-Foot Supersonic Wind Tunnel was the most powerful propulsion wind tunnel in the nation. The facility was part of Congress’ Unitary Plan Act which coordinated wind tunnel construction at the NACA, Air Force, industry, and universities. The 10- by 10 was the largest of the three NACA tunnels built under the act. The 20-foot diameter eight-stage axial flow compressor, seen in this photograph, could generate air flows up to Mach 2.5 through the test section. The stainless steel compressor had 584 blades ranging from 1.8 to 3.25 feet in length. This main compressor was complemented by a secondary axial flow compressor. Working in tandem the two could generate wind streams up to Mach 3.5.

 

The Cleveland Chamber of Commerce presented NACA Lewis photographer Bill Bowles with a second place award for this photograph in their Business and Professional category. The photograph was published in October 1955 edition of its periodical, The Clevelander, which highlighted local professional photographers.

 

NASA Media Usage Guidelines

 

Credit: NASA

Image Number: GRC-1955-C-39730

Date: September 1, 1955

18,581 views
106 faves
2 comments
Uploaded on August 18, 2022
Taken on September 1, 1955