LOURDES NATIONAL HIGH SCHOOL

Panglao, Bohol

1st SUMMATIVE TEST IN COMPUTER SYSTEMS SERVICING GRADE 12

Name: ______________________ Grade Level & Section: ________________ Score: ______

I. MULTIPLE CHOICE. Read each question carefully and write the letter of the correct answer on your answer
sheet. Erasures are not allowed.

1. In this type of topology, all the computers are connected to a single hub through a cable.
A. Bus B. Mesh C. Ring D. Star
2. It is a network type in which every computer and network device is connected to a single cable.
A. Bus B. Mesh C. Ring D. Star
3. In this technique, the same data is transmitted to all the network nodes, hence no routing logic is required.
A. Bridging B. Flooding C. Routing D. Switching
4. It is a point-to-point connection to other nodes or devices.
A. Bus B. Mesh C. Ring D. Star
5. In this technique, the nodes have a routing logic, as per the network requirements.
A. Bridging B. Flooding C. Routing D. Switching
6. It is a device that is used to test the strength and connectivity of a particular type of cable or other wired
assemblies.
A. Crimper B. LAN tester C. Loopback adapter D. RJ45
7. This is a standard physical Network Interface used for connecting telecommunications equipment commonly, a
computer networking equipment.
A. Crimper B. LAN tester C. Loopback adapter D. RJ45
8. It is used to join the RJ-45 and RJ-11 connectors to both ends of either phone or CAT5 cable.
A. Crimper B. LAN tester C. Loopback adapter D. RJ45
9. This allows users to remotely access another computer such as a server, network device, or other computer.
A. ftp B. netstat C. pathping D. telnet
10. It helps in determining TCP/IP Networks IP address as well as determine issues with the network and assists in
resolving them.
A. getmac B. ipconfig C. ping D. tracert
11. This command can be utilized to verify a network connection as well as to verify your network settings.
A. getmac B. ipconfig C. ping D. tracert
12. It sends multiple Echo Request messages to each router between a source and destination over a period of time
and then computes results based on the packets returned from each router.
A. ftp B. netstat C. pathping D. telnet
13. A PC is not able to connect to a wired network. Pinging the loopback address is successful, but the gateway
cannot be reached. On the network switch all the interface lights are on, except for the interface connected to
the PC. The LED on the network card is off. What is the most likely cause of this problem?
A. The gateway needs to be fixed. C. The network switch is faulty.
B. The network cable is faulty. D. The PC has an incorrect IP address for the DNS server.
14. Users in a recently installed wireless network are complaining of slow data transfer and frequent loss of
connectivity. The technician checks that the wireless security is correctly implemented, and there is no evidence
of unauthorized users on the network. Which two problems might the technician suspect? (Choose two.)
A. There is interference from outside sources.
B. The DHCP server is faulty.
C. The wireless signal is too weak.
D. The antenna on the access point is too powerful.
E. The network passwords need to be reissued to the users.
15. A group of users is unable to connect to the network. When testing several of the PCs and issuing the command
ipconfig, the technician notices that all of them have an IP address in the 169.254.x.x range. What is the most
likely cause of this problem?
A. The Internet connection is down. C. The DHCP server is not operational.
B. The gateway address is incorrect. D. The DNS server is not operational.
16. A technician finds that occasionally when a network printer is restarted, clients are unable to print to it,
receiving a "Document failed to print" message. What is the probable cause of this?
A. The printer is configured to get an IP address using DHCP.
B. The toner level in the EP cartridge is low.
C. The drum is damaged.
D. The printer does not have enough memory.
 17. A freshly installed Windows 7 laptop is plugged into the network and configured with an IP address. The
technician then attempts to ping the laptop from another computer. While the laptop can connect to other
devices, the ping requests fail. What is the likely cause?
A. The Windows Firewall is blocking ping requests. C. The network drivers for the NIC are out of date.
B. The port speed for the NIC is incorrect. D. TPM must be enabled.
18. It bundles multiple network ports together to connect incoming and outgoing lines including those for local area
networks.
A. Modem B. Patch Panel C. Router D. Switch
19. This is a device that converts data into a format suitable for a transmission medium.
A. Modem B. Patch panel C. Switch D. WAP
20. It is a computer network which spans over a large geographical area such as a country or the world.
A. Local Area Network C. Personal Area Network
B. Metropolitan Area Network D. Wide Area Network
21. This is a device that allows other Wi-Fi devices to connect to a wired network.
A. Patch panel B. Router C. Switch D. WAP
22. It is an enclosed conduit that forms a physical pathway for electrical wiring.
A. Modular box B. Patch panel C. Raceway D. Rack mount
23. This is a computer network which distances over a small geographical area such as home, building, office, school
etc.
A. Local Area Network C. Personal Area Network
B. Metropolitan Area Network D. Wide Area Network
24. It is a device that filters and forwards packets between LAN segments.
A. Hub B. Router C. Switch D. WAP
25. This is a device that forwards data packets along networks.
A. Modem B. Router C. Switch D. WAP
26. It is used to connect not the same devices or unlike devices.
A. Coaxial cable B. Crossover cable C. Fiber optic cable D. Straight-through cable
27. This creates a secure barrier between your network and the internet, blocking security threats.
A. Antivirus B. Anti-malware C. Hardware firewall D. Windows Defender
28. It is not as intelligent as the switch.
A. Hub B. Modem C. Router D. WAP
29. This is used to connect one network device to other network devices or to connect two or more computers to
share files and printer.
A. ISP B. Network cable C. PC D. Printer
30. It refers to the planning of the implementation of a computer network infrastructure.
A. Network design B. Network infrastructure C. Network protocol D. Network topology

II. MATCHING TYPE. Match column A with column B. Write the letter of the correct answer on your answer sheet.
Erasures are not allowed.
A B
1. This cable is commonly used in the television industries. A. Client/server
2. It is a computer network in which one centralized, powerful computer is B. Coaxial
a hub to which workstation is connected. C. Fiber optic
3. This is the most expensive type of cable. D. getmac
4. It consists of two or more computers that share files without requiring a E. Modular box
server computer. F. netstat
5. This is the cheapest cable used in computer networking. G. nslookup
6. It is used for telephone systems, data networks, and low- H. Patch panel
speed serial connections. I. Peer-to-peer
7. The extra covering of this cable provides extra protection to J. STP
prevent electromagnetic interference. K. tracert
8. This command displays information that you can use to L. UTP
diagnose Domain Name System (DNS) infrastructure.
9. It is a command used to visually see a network packet being sent and received
and the number of hops required for that packet to get to its destination.
10. This command displays active TCP connections.
 ANSWER KEY
I. MULTIPLE CHOICE.
1. D
2. A
3. B
4. B
5. C
6. B
7. D
8. A
9. D
10. C
11. B
12. C
13. B
14. A & C
15. C
16. A
17. A
18. B
19. A
20. D
21. D
22. C
23. A
24. C
25. B
26. D
27. C
28. A
29. B
30. A
II. MATCHING TYPE
1. B
2. A
3. C
4. I
5. L
6. E
7. J
8. G
9. K
10. F