SDO Navotas TLE10 CSS Q3 M2 Installing-And-Configuring-Computer-Systems FVa
SDO Navotas TLE10 CSS Q3 M2 Installing-And-Configuring-Computer-Systems FVa
SUPPLEMENTARY
LEARNING MATERIALS
for Junior High School
Learners
LEARNING COMPETENCY:
LO 4. Install Application Software
4.2 Carry out variation to application software in accordance to customer/
client requirements
TLE_IACSS9-12ICCS-IIIa-e31
HOW TO USE THIS SUPPLEMENTARY LEARNING
MATERIALS
Before you start answering the module, I want you to set aside other
tasks that will disturb you while enjoying the lessons. Read the simple
instructions below to successfully enjoy the objectives of this kit. Have fun!
1. Follow carefully all the contents and instructions indicated in every
page of this module.
2. Write on your notebook or any writing pad the concepts about the
lessons. Writing enhances learning, that is important to develop
and keep in mind.
3. Perform all the provided activities in the module.
4. Let your facilitator/guardian assess your answers.
5. Analyze conceptually the posttest and apply what you have learned.
6. Enjoy studying!
DISK MANAGEMENT
EXPECTATIONS
2
PRETEST
Directions: Read each statement carefully. Choose the letter which corresponds to the correct
answer and write your answers on a separate sheet of paper.
1. Any ordinary files are automatically relocated on the disk to create the new
unallocated space. What is being described in the sentence?
A. shrink in disk C. formatting
B. disk cleanup D. optimizing Drives
2. This contains the operating system files. There can be up to four per hard drive and cannot
be subdivided into smaller sections.
A. primary partition C. extended partition
B. active partition D. logical drive
3. This is used to boot the computer and contains the boot and system files. There can be
only one of this per disk.
A. primary partition C. extended partition
B. active partition D. logical drive
4. This can be situated only as one per hard drive, but it can be subdivided into smaller
sections.
A. primary partition C. extended partition
B. active partition D. logical drive
5. It restores the computer's system software back to its factory state without deleting user
files or removing modern apps
A. advanced startup options C. refresh your PC
B. reboots execution D. remote Installation
6. Which Windows utility that scans disks for bad sectors and tries to repair them?
A. system restore C. disk cleanup
B. optimizing drives service D. check disk
7. __________ is the process that prepares a file system in a partition for files to be stored.
A. disk cleanup C. arrangement
B. construction D. formatting
8. This has the ability to create volumes that span across more than one disk. The size of
the volumes can be changed after they have been created.
A. dynamic disk C. disk cleanup
B. basic disk D. storage spaces
9. This is a utility built into different operating systems which can be used to create, delete,
format partitions, assign drive letters, and much more.
A. basic disk C. storage spaces
B. disk cleanup D. disk management
10. Which disk organizational method allows a volume to be created across multiple
drives (It can be also in different sizes and types)?
A. dynamic disk C. storage spaces
B. mounted drive D. basic disk
3
LOOKING BACK
Directions: Identify what is being described in the sentence. Write your answer on a
separate sheet of paper.
BRIEF INTRODUCTION
Disk Management is a utility built into different operating systems which can be used to
create, delete, format partitions, assign drive letters, and much more. Disk Management can also
be used to view partitions and their formatted file systems on the hard drive. The most common
way to access Disk Management is via Computer Management.
Disk Management
Disk Management is a Microsoft Windows utility first introduced in Windows XP as a replacement
for the disk command. It enables users to view and manage the disk drives installed in their
computer and the partitions associated with those drives. As the image below shows, each drive
is displayed followed by the layout, type, file system, status, capacity, free space, % free, and
fault tolerance.
The Disk Management command is the same in all versions of Windows, so these instructions
apply to Windows 8, Windows 7, Windows Vista, and Windows XP. Follow these easy steps to
start Disk Management from the Command Prompt in Windows:
In Disk Management’s Graphical view, right-click an unallocated or free area, and then click New
Simple Volume. This starts the New Simple Volume Wizard.
4
Figure 1 - Disk Management
https://www.slideshare.net/ArshadQureshi5/disk-management-dm
Read the Welcome page and then click Next.
The Specify Volume Size page specifies the minimum and maximum size for the volume in
megabytes and lets you size the volume within these limits. Size the partition in megabytes using
the Simple Volume Size field and then click Next.
On the Assign Drive Letter or Path page, specify whether you want to assign a drive letter or path
and then click Next. The available options are as follows:
Use the Format Partition page to determine whether and how the volume should be formatted. If
you want to format the volume, choose Format This Volume with the Following Settings, and
then configure the following options:
Click Next, confirm your options, and then click Finish.
5
Figure 3 - Disk Management, New Simple Volume
https://www.slideshare.net/ArshadQureshi5/disk-management-dm
The Windows 7 Disk Management tool will now show the space configured as a new partition.
In Disk Management, right-click the volume that you want to shrink, and then click Shrink
Volume.
6
https://www.slideshare.net/ArshadQureshi5/disk-management-dm
In the field provided in the Shrink dialog box, enter the amount of space by which to
shrink the disk. Click Shrink.
When you shrink a partition, any ordinary files are automatically relocated on the disk to
create the new unallocated space. There is no need to reformat the disk to shrink the
partition
ACTIVITIES
Directions: Using your smartphone or webcam, record a short video discussing the
use of disk management? Keep your video short with a maximum of 2-3 minutes. Send your video
on google classroom.
7
REMEMBER
Use Disk management to check free hard drive space. Look under the Capacity and Free
space columns (in the Disk List or Volume List view) to see the total storage capacity of all the
disks as well as how much free space is remaining, which is expressed in units as well as a
percentage.
Directions. Complete the statement below based on what have you learned from the
lesson. Write your answers on a separate sheet of paper.
POST TEST
Directions: Read each statement carefully. Choose the letter which corresponds to the
correct answer and write your answers on a separate sheet of paper.
1. This has the ability to create volumes that span across more than one disk. The
size of the volumes can be changed after they have been created.
A. dynamic disk
B. basic disk
C. disk cleanup
D. storage spaces
8
2. This is a utility built into different operating systems which can be used to create,
delete, format partitions, assign drive letters, and much more.
A. basic disk C. storage spaces
B. disk cleanup D. disk management
3. Which disk organizational method allows a volume to be created across multiple
drives (It can be in different sizes and types)?
A. dynamic disk C. storage spaces
B. mounted drive D. basic disk
4. This refers to any ordinary files are automatically relocated on the disk to create
the new unallocated space. What is being described in the sentence?
A. shrink in disk C. formatting
B. disk cleanup D. optimizing drives
5. This contains the operating system files. There can be up to four per hard drive
and cannot be subdivided into smaller sections.
A. Primary partition C. Extended partition
B. Active partition D. Logical drive
6. This is used to boot the computer and contains the boot and system files. There
can be only one of this per disk.
A. primary partition C. extended partition
B. active partition D. logical drive
7. This can be situated as only one per hard drive, but it can be subdivided into
smaller sections.
A. primary partition C. extended partition
B. active partition D. logical drive
8. It restores the computer's system software back to its factory state without deleting
user files or removing modern apps
A. advanced startup options C. refresh your PC
B. reboots execution D. remote installation
9. Which Windows utility can scan disks for bad sectors and tries to repair them?
A. system restore
B. optimizing drives service
C. disk cleanup
D. check disk
10. __________ is the process that prepares a file system in a partition for files to be
stored.
A. disk cleanup
B. construction
C. arrangement
D. formatting
9
ANSWER KEY
10. C
9. D 10. D
8. A 9. D
7. D
updates 8. C
6. D
5. Compatibility 7. C
5. C
4. C 4. Security 6. B
3. B 3. Patches 5. A
2. A 2. Software updates 4. A
1. A 1. Service pack 3. C
2. D
Pretest Looking back 1. A
POST TEST
REFERENCES
Rosalie P. Lujero, K to 12 Basic Education Curriculum- Technology and Livelihood
Education Learning Module – Grade 9 - Information and Communications
Technology Computer Hardware Servicing CHS 9.
10