COMPUTER SYSTEM SERVICING

(3RD QUARTER EXAM CSS 12)

Instruction: Choose only the correct other, what are the possible causes if
answer. the network is using static IP
addresses?
1. What if the computer you have to A. Wrong IP address
network is more than 100, and you B. Maybe some computers don’t
have noticed that the network is belong to the workgroup
slowing down, what are you going to C. Wrong subnet mask
do? Give at least one D. All of the above
recommendation?
A. Divide the network into groups or 6. Binary Code of 16
subnet the network A. 00101 B. 10000
B. Create server C. 01901 D. 00100
C. Create Hotspot
D. Use wifi 7. Binary code of 37
A. 1111001 B. 0110011
2. What would you do if the devices C. 01010101 D. 100101
that you are going to network are far
from each other? 8. Binary code of 21
A. Use an extender or repeater A. 00110 B. 01091
B. Use Hotspot C. 10101 D. 10102
C. Use modem
D. Create Server 9. Binary code of 74
A. 0000110 B. 100000
3. What would you do if you suspect C. 1001010 D. 100110
that the cause of the trouble in the
network is the cable? 10. After configuring the network
A. Get a LAN tester and check the interface card, how will you going to
cable test the connectivity of your network?
B. Replace the Cable wire A. Ping each other B. Using net view
C. Crimp another cable wire C. msconfig D. temp
D. Use wifi adapter
11. What type of cable will you use to
4. After checking the cable with LAN connect two computers?
tester and the tester indicates that the A. Crossover cable
output of the two ends swapped: pin B. Straight through
one goes to pin three from the other C. Peer to peer
end, and pin two goes to pin six on the D. All of the above
other end, what does it signify? Is it
good or bad? 12. What is the common type of
A. The cable is good and it is a cabling standards used for straight thru
crossover type cable cable?
B. Use Extended Repeater A. 568B standard B. 568A
C. Use Hotpot C. Crossover D. All of the
D. Create Cable wire above

5. After replacing a good cable, still the 13. What is the term used for software
computers cannot connect to each which is not part of the OS?
 A. Third party software/installer
B. installer 22. ____________
C. Application A. List disk B. Select partition 1
D. Driver packs C. Active D. Clean

14. What do you call a bootable disk 23. ____________

that contains a full usable OS? A. Active B. Clean
A. Live CD/DVD C. List disk D. Diskpart
B. Boot loader
C. USB 24. ____________
D. Harddrive A. Clean B. List disk
C. cmd D.Format fs=ntfs
15. What Windows Server 2008
feature is a special installation option 25. ____________
that creates a minimal environment for A. Clean B. format fs=ntfs
running only specific service or roles? C. List disk D. Assign
A. Core i3
B. Server Core 26. You want to set up a dual-boot
C. Intel core scenario between Windows 7 and
D. Add Roles Windows Server 2008. How would you
do this?
Test II. Make bootable flash drive A. Partition Hard Drive
using cmd commad in order. (Choose B. Install Windows 7 first
the Correct Answer) C. Install Windows Server 2008 in
the second partition
16._____________ D. All of the above
A. Active B. cmd
C. Diskpart D. list disk 27. What do you call the computer
software which you configure before
17. ____________ installing the OS?
A. Diskpart B. clean A. Boot Loader B. BIOS
C. active D. all of the above C. BIOSTAR D. Windows8 R2

18. ____________ 28 How many RID (Relative

A. Clean B. list disk Identification) Master in one domain?
C. Create Partition D. Select disk 1 A. Single B. Triple
C. Four D. Two
19. ____________
A. List Disk B. Clean 29. What would you advise to a client
C. Active D. Select disk 1 who wants to improve the computer’s
built-in video card?
20. ____________ A. Buy an internal video card having
A. Active B. Clean higher memory capacity
C. list disk D. format fat32 B. Repair the v-card
C. Buy another PC
21. ____________ D. All of the above
A. Create partition 2
B. Create partition primary 30 What may be the problem and what
C. Select Partition 1 should be done if the display does not
D. List disk
match what you expect to view on the
monitor? 36. What will you do if after installing
A. Install the Lan Driver both the IDE hard drive and optical
B. Install the video driver drive you have noticed that only one
C. Install Ethernet drive is working?
D. Replace Memory Card A. Check the jumper setting
B. Check the CPU ]
31. What type of screw driver will you C. Check the Power Supply
use for small screws usually found in D. Check the PC
Compaq and Apple computers?
A. Philipp Screwdriver 37. If after assembling a brand-new
B. Flat Screwdriver computer the monitor does not display
C. Torx Screwdriver any image or character, what may be
D. Long nose the possible causes?
A. Power on switch
32. How will you check and what B. Monitor cable
instrument will you use to determine C. Monitor the PC
whether the power supply is providing D. A & B
enough voltage output or not?
A. Voltmeter B. Thermometer 38. Enumerate possible causes when
C. Lan Tester D. MultiTester the computer does not produce any
sound from the speaker
33. What will you do if a customer A. Speaker’s power may not be
wants to install an operating system in turned on
his PC but does not have an optical B. the signal cable of the speaker
drive? C. sound card driver not installed
A. Cd Drive D. All of the Above
B. Create a bootable flash disk
C. Create UsbDrive 39. Where should you keep peripheral
D. All of the Above cards or computer memory cards?
A. Anti-static bag
34. What may be the problem if a B. Anti-static Mat
computer does not recognize a C. Anti-static wrist wrap
bootable flash drive? What would you D. Anti-histamine
do to resolve this?
A. Configure the BIOS to boot on the 40. What should you do after installing
flash drive peripheral devices such as a sound
B. Reboot the Bios card?
C. Bootloader A. Install Application
D. Harddisk Priorities B. Install Utilities
C. Install driver
35. After testing the assembled D. Install Operating System
product, you have noticed that the
product is not working, what are the 41. What should you configure in the
possible causes? BIOS when you are going to install an
A. Cold Solder operating system using an optical
B. Wrong component placement media?
A. Configure Harddisk
C. wrong polarity B. Boot sequence
D. All of the above C. Boot the system
 D. Reboot the System unit A. Site B. Network
C. IP Address D. details
42. Prior to assembling a computer,
what should you wear to protect 47. When modifying the scheme,
computer parts from ESD? Microsoft recommends adding
A. Anti-static wrist strap administrator, to what group only for
B. Anti-static bag the duration of the task?
C. Gloves A. Schema Task B. Multi task
D. Googles C. PC task D. Operating
system
43. What should you do if suddenly
there is a lightning storm that occurs 48. What kind of cable are you going
while assembling a computer? to use if you want to network two
A. Power off and unplug computer units only?
B. Hibernate the Computer A. Crossover network
C. Turn off the sound card of the PC B. Straight through
D. Cover the PC C. T568B
D. All of the above
44. What should you do if accidentally,
water spilled on the computer which 49. Based on rules, what type of
you are currently using? network would you suggest to your
A. Cover the PC client who wants to network more than
B. Power off the unit immediately 100 computers?
C. Separate the battery A. Disc less
D. All of the above B. Client server type
C. Workgroup
45. What do you call a bootable disk D. Peer to peer
that contains a full usable OS? 50. What type of network would you
A. Live CD/DVD recommend if your client has only few
B. Live USB computer units?
C. Live Installer A. Server type network
D. Live Operating System B. Peer to Peer
C. Discless
46. What term is used to define one or D. Workgroup
more IP subnets that are connected by
the fast links?